Sub-X 3m

Buy In Store/Arrange Specialist Delivery/Installation

Telephone 01922 493 499
or Email us here about this product

£75.00

Description

Sub-X uses two identical solid 1.25% Silver-Plated Long-Grain Copper conductors for positive and negative. Solid conductors eliminate strand-interaction distortion. Foamed-PE insulation minimizes signal smearing. A 100% coverage shield ensures noise-free performance. Gold-plated high-conductivity brass plugs are attached with specially-formulated AQ Silver Solder.

SOLID 1.25% SILVER-PLATED LONG-GRAIN COPPER CONDUCTORS: Silver-Plated Copper always provides superior performance for video and digital audio. Unfortunately when used for full-range analog audio, the discontinuity of silver plating over copper causes high frequencies to sound edgy and harsh. However, when used only for subwoofer frequencies, Silver-Plated Copper’s “artificial edge” actually enhances the articulation and intelligibility of low-frequency information. Do not use AudioQuest’s Silver-Plated Copper subwoofer cables for full-range audio.

FOAMED-POLYETHYLENE INSULATION: Any solid material adjacent to a conductor is actually part of an imperfect circuit. Wire insulation and circuit board materials all absorb energy (loss). Some of this energy is stored and then released as distortion. Sub-X uses air-filled Foamed-Polyethylene Insulation on both conductors because air absorbs next to no energy and Polyethylene is low-loss and has a benign distortion profile. Thanks to all the air in Foamed-PE, it causes much less of the out-of-focus effect common to other materials.

SYMMETRICAL CONDUCTORS: Sub-X has identical conductors for the positive and ground connections. Underneath the 100% coverage foil shield is a bare conductor, exactly the same as the insulated center conductor. The conductor under the shield does double duty as a low distortion audio connection, and as the drain wire connecting the shield to ground.

TERMINATIONS: Precision gold-plated plugs are carefully attached with the very best solder. Through choice of flux and metallurgy, AQ solder has been optimized to make a low-distortion connection. All solder, including “silver solder,” is a lousy conductor. The difference you hear between solders is a result of connection quality. AQ solder does not have a high silver content because the more silver there is in solder, the more difficult it is to make a good connection.

GROUNDING: Sometimes there is a hum problem unless the subwoofer and AV receiver (or surround-sound processor) are attached to each other using a separate wire. If your system has a hum problem, try attaching the little spade-lug tails to the metal chassis of the subwoofer amplifier and to the chassis of the sending component. Usually, this extra wire will not be needed

Specification

  • AudioQuest Sub-X Subwoofer Cable
  • Length: 3 metre
  • Geometry: Symmetrical Coax
  • Metal: Solid 1.25% Silver
  • Gauge: 22 AWG
  • Dielectric: Foamed PE
  • Termination: RCA only
  • Jacket Colour: Black/Grey/Red Braid
  • Lifetime Warranty

 

Reviews

There are no reviews yet.

Be the first to review “Sub-X 3m”

Your email address will not be published. Required fields are marked *